.................Previous Page........................................ Next Page If There Is One
..............................--- Computer/Router Mount ---
.........
The bottom of the mount.
.........
Turned over and the computer sits on this side like....
.........
..this.
.........
Sides were added with holes to correspond to the vents on the computer case.
.........
View from the other side.
.........
This piece was made as a filler piece....
.........
...that just covers an 'ugly' spot on the side.
.........
The keyboard fits behind a small panel above a speaker to the right of the computer. Compare the size of the keyboard to the computer/router and you get an idea of how small the computer is.
.........
Here everything has been stained and given 3 coats of an indoor/outdoor urethane.
.........
The right arrow points to a piece of aluminu with a piece of wood on both sides. It is held in place by a single screw (left arrow). The piece locks the computer down and also keeps the router in place. The router can't slide out the back as the bulkhead there drops a little. To remove the computer you have to remove that screw and bracket.
I put the felttip pen there to once again give an idea of size.
.........
The computer/routher/POE and keyboard are out of the way and in an area that wasn't of much good for anything. You can still easily go past it into the aft bed.
.........
Here the monitor is over in a storage location with the screen turned towards the cabin and here....
.........
....the monitor has been rotated so that it is facing the computer. The monitor mount build is ( HERE ).
I hope/feel this is going to be a good location for the computer/chart plotter.